Nokia 7330 - Monitor CLI Command; 5.3 Monitor CLI Commands; Filter Commands; Filter

Monitor Commands
78
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
5.2.1 Monitor CLI Command
monitor
— filter
— ip ip-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
— ipv6 ipv6-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
— mac mac-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
— lag lag-id [lag-id...(up to 5 max)] [interval seconds] [repeat repeat] [absolute | rate]
— port port-id [port-id...(up to 5 max)] [interval seconds] [repeat repeat] [absolute | rate]
— router [router-id]
— bgp
— neighbor ip-address [ip-address...(up to 5 max)] [interval seconds][repeat repeat] [absolute
|
rate]
— isis
— statistics [interval seconds] [repeat repeat] [absolute | rate]
— ldp
— session ldp-id [ldp-id...(up to 5 max)] [interval seconds] [repeat repeat][absolute | rate]
— statistics [interval seconds] [repeat repeat][absolute | rate]
— ospf
— interface interface [interface...(up to 5 max)] [interval seconds][repeat repeat] [absolute |
rate]
— neighbor ip-address [ip-address...(up to 5 max)] [interval seconds][repeat repeat] [absolute |
rate]
— rip
— neighbor neighbor [neighbor...(up to 5 max)] [interval seconds][repeat repeat] [absolute |
rate]
— service
— id service-id
— sdp {sdp-id[:vc-id] | far-end ip-address} [interval seconds] [repeat repeat][absolute | rate]
5.3 Monitor CLI Commands
The following commands are described below:
• Filter Commands
• LAG Commands
• Port Commands
• Router Commands
• Service Commands
5.3.1 Filter Commands
5.3.1.1 filter
Table 90 filter command
Item Description
Syntax filter
Context monitor
(1 of 2)