Nokia 7330 - Lldp; Show Commands; Tx-Interval

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Link Layer Discovery Protocol
Issue: 10 3HH-11982-AAAA-TQZZA 217
9.3.1.8 tx-interval
Table 248 tx-interval command
9.3.2 Show Commands
9.3.2.1 lldp
Table 249 lldp command
Table 250 describes the LLDP configuration output fields.
Table 250 LLDP configuration output fields
Item Description
Syntax tx-interval interval
no tx-interval
Context configure>system>lldp
Description This command configures the LLDP transmit interval time.
The no form of the command returns the value to the default value.
Default 5
Parameters interval — Specifies the LLDP transmit interval time.
Values: 1..100
Item Description
Syntax lldp
Context show>system
Description This command shows the Link Layer Discovery Protocol (LLDP) system information.
Label Description
Transmit Interval Shows the LLDP transmit interval time configured.
Hold Multiplier Shows the configured hold-multiplier of the LLDP transmit interval.
Reinit Delay Shows the configured re-init delay time before re-initializing LLDP on a port.
Tx Credit Max Shows the tx-credit max configured, to set the maximum consecutive LLDPDUs
transmitted.
(1 of 2)