Nokia 7330 - Mep; Table 232 Mep Command

Ethernet Connection Fault Management
198
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
====================================================================
8.12.3.4 mep
Table 232 mep command
Table 233 shows the command output fields.
Table 233 Show eth-cfm mep command output fields
Item Description
Syntax mep mep-id domain md-index association ma-index [loopback] [linktrace]
Context show>eth-cfm
Description This command displays Maintenance Endpoint (MEP) information.
Parameters domain md-index - Displays the index of the MD to which the MP is associated, or 0, if none.
association ma-index - Displays the index to which the MP is associated, or 0, if none.
loopback - Displays loopback information for the specified MEP.
linktrace - Displays linktrace information for the specified MEP.
Label Description
Md-index Index of the MD
Ma-index Index of the MA
Mep Id MEP Id
Sdp Id SDP Id on which MEP configured
FngState Indicates the different states of the MEP Fault Notification Generator State Machine
LowestDefectPri Lowest priority defect configured
Defect Flags Defect flags set currently
Mac Address Mac address of the MEP
Ccm Tx Number of CCM frames transmitted on this MEP
Fault Propagation Fault propagation status
CcmLastFailure
Frame
Display last ccm failure frame
XconccmFailure
Frame
Display xcon failure frame
Direction Direction of the MEP
Admin Admin state of the MEP
CCM-Enable Ccm enabled state on the MEP
(1 of 2)