Ethernet Connection Fault Management
194
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
8.12.2.5 single-ended-loss-test
Table 225 single-ended-loss-test command
8.12.3 Show Commands
8.12.3.1 association
Table 226 association command
Item Description
Syntax single-ended-loss-test mac-address mep mep-id domain md-index association ma-index
[priority priority] [interval {1s}] [send-count send-count]
Context oam>eth-cfm
Description This command specifies to initiate a loss measurement test between the specified
mac-address and the specified mep-id MEP.
Parameters The parameters with their values and defaults are as follows:
• mac-address — Specifies a unicast destination MAC address.
Values: xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx, where xx is a hexadecimal number.
• mep mep-id — Specifies the local mep-id.
Values: 1 — 8191
• md-index — Specifies the index of the MD to which the MEP is associated, or 0, if none.
Values: 1 to 4294967295
• ma-index — Specifies the index to which the MEP is associated, or 0, if none.
Values: 1 to 4294967295
• send-count — Specifies the number of LMM messages to send, expressed as a decimal
integer
Values: 2 to 5
Default: 2
• interval {1s} — Specifies the interval between groups of consecutive LMM packets (for
example, if send-count is 5 and interval is 1s, then 5 LMM packets are sent at 1-s intervals)
Values: 1s
Default: 1s
• priority — Specifies the priority
Values: 0 to 7
Default: 7
Item Description
Syntax association [ma-index] [detail]
Context show>eth-cfm
Description This command displays eth-cfm association information.
(1 of 2)
To Next Page
Loading...
