Nokia 7330 - Port Commands; Port; Table 95 Port Command

Monitor Commands
84
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
A:ALA-12# monitor lag 12
============================================================================
Monitor statistics for LAG ID 12
============================================================================
Port-id Input Input Output Output Input Output
Bytes Packets Bytes Packets Errors Errors
----------------------------------------------------------------------------
At time t = 0 sec (Base Statistics)
----------------------------------------------------------------------------
nt-a:sfp:1 2168900 26450 64 1 0 0
nt-a:sfp:2 10677318 125610 2273750 26439 0 0
nt-a:sfp:3 2168490 26445 0 0 0 0
----------------------------------------------------------------------------
Totals 15014708 178505 2273814 26440 0 0
----------------------------------------------------------------------------
At time t = 5 sec (Mode: Delta)
----------------------------------------------------------------------------
nt-a:sfp:1 0 0 0 0 0 0
nt-a:sfp:2 258 3 86 1 0 0
nt-a:sfp:3 82 1 0 0 0 0
----------------------------------------------------------------------------
Totals 340 4 86 1 0 0
============================================================================
A:ALA-12#
5.3.3 Port Commands
5.3.3.1 port
Table 95 port command
Item Description
Syntax port port-id [port-id...(up to 5 max)[interval seconds] [repeat repeat] [absolute | rate]
Context monitor
Description This command enables port traffic monitoring. The specified port(s) statistical information
displays at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the specified port(s). The subsequent
statistical information listed for each interval is displayed as a delta to the previous display.
When the rate keyword is specified, the “rate per second” for each statistic is displayed instead
of the delta.
Monitor commands are similar to show commands but only statistical information displays.
Monitor commands display the selected statistics according to the configured number of times
at the interval specified.
(1 of 2)