Nokia 7330 - LAG Commands; Lag; Table 94 Lag Command

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Monitor Commands
Issue: 10 3HH-11982-AAAA-TQZZA 83
----------------------------------------------------------------------------
Ing. Matches: 0 Egr. Matches : 0
----------------------------------------------------------------------------
At time t = 15 sec (Mode: Rate)
----------------------------------------------------------------------------
Ing. Matches: 0 Egr. Matches : 0
============================================================================
A:ALA-1>monitor>filter#
5.3.2 LAG Commands
5.3.2.1 lag
Table 94 lag command
Sample output:
Item Description
Syntax lag lag-id [lag-id...(up to 5 max [interval seconds] [repeat repeat] [absolute | rate]
Context monitor
Description This command monitors traffic statistics for Link Aggregation Group (LAG) ports. Statistical
information for the specified LAG ID(s) displays at the configured interval until the configured
count is reached.
The first screen displays the current statistics related to the specified LAG ID. The subsequent
statistical information listed for each interval is displayed as a delta to the previous display.
When the rate keyword is specified, the “rate per second” for each statistic is displayed instead
of the delta.
Monitor commands are similar to show commands but only statistical information displays.
Monitor commands display the selected statistics according to the configured number of times
at the interval specified.
Parameters lag-id — The number of the LAG.
Default: none — The LAG ID value must be specified.
Values: 1 — 64
interval seconds — Configures the interval for each display in seconds.
Default: 10 seconds
Values: 5 — 60
repeat repeat — Configures how many times the command is repeated.
Default: 10
Values: 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.