"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Events and Logs
Issue: 10 3HH-11982-AAAA-TQZZA 129
6.8.5.4 router
Table 120 router command
6.8.5.5 severity
Table 121 severity command
Item Description
Syntax router {eq | neq} router-name [regexp]
no router
Context configure>log>filter>entry>match
Description This command specifies the log event matches for the router.
Parameters eq — Determines if the matching criteria should be equal to the specified value.
neq — Determines if the matching criteria should not be equal to the specified value.
router-name — Specifies a router name up to 32 characters to be used in the match criteria.
regexp — Specifies the type of string comparison to use to determine if the log event matches
the value of router command parameters. When the regexp keyword is specified, the string in
the router command is a regular expression string that will be matched against the subject
string in the log event being filtered.
Item Description
Syntax severity {eq | neq | lt | lte | gt | gte} severity-level
no severity
Context configure>log>filter>entry>match
Description This command adds an event severity level as a match criterion. Only one severity command
can be entered per event filter entry. The latest severity command overwrites the previous
command.
The no form of the command removes the severity match criterion.
Default no severity — No severity level match criterion is specified.
Parameters eq | neq | lt | lte | gt | gte — This operator specifies the type of match. Valid operators are:
• eq: equal to
• neq: not equal to
• lt: less than
• lte: less than or equal to
• gt: greater than
• gte: greater than or equal to
severity-name — The ITU severity level name. See Table 107 for the severity names and
corresponding numbers per ITU standards M.3100 X.733 & X.21 severity levels.
Values: cleared, indeterminate, critical, major, minor, warning
To Next Page
Loading...
