"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Events and Logs
Issue: 10 3HH-11982-AAAA-TQZZA 135
6.8.8 Clear Commands
Table 132 describes the log-ID command.
Table 132 log-id command
Filter ID The value is the index to the entry which defines the filter to be applied to this log's
source event stream to limit the events output to this log's destination. If the value is 0,
then all events in the source log are forwarded to the destination.
Admin State Up — Indicates that the administrative state is up.
Down — Indicates that the administrative state is down.
Oper State Up — Indicates that the operational state is up.
Down — Indicates that the operational state is down.
Logged The number of events that have been sent to the log source(s) that were forwarded to
the log destination.
Dest ID The event log stream destination.
Size The allocated memory size for the log.
Time format The time format specifies the type of timestamp format for events sent to logs where
log ID destination is either syslog or file.
When the time format is UTC, timestamps are written using the Coordinated Universal
Time value.
When the time format is local, timestamps are written in the system's local time.
Label Description
(2 of 2)
Item Description
Syntax log-id log-id
Context clear>log
Description This command clears event logs, including default system logs
Parameters log-id — The log ID number, expressed as a decimal integer.
Values: 1 - 100
To Next Page
Loading...
