Nokia 7330 - System Administration Commands; Display-Config; Enable-Tech; Table 13 Display-Config Command

System Management
32
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
3.5.2 System Administration Commands
3.5.2.1 display-config
Table 13 display-config command
3.5.2.2 enable-tech
Table 14 enable-tech command
Context configure>system>
Description This command specifies the default service level ether type to be used for all v-VPLS services
if the per-service ether type is not configured.
Parameters etype — etype value (can be given in hexadecimal or decimal).
Range: hex: 0x0600...0xffff
decimal: 1536...65535
Default: 0x8100
Item Description
(2 of 2)
Item Description
Syntax display-config
Context admin
Description The current IHub configuration can be viewed by using the command.
Item Description
Syntax [no] enable-tech
Context admin
Description This command enables the shell and kernel commands.