Nokia 7330 - Sdp; Table 105 ID Command; Table 106 Sdp Command

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Monitor Commands
Issue: 10 3HH-11982-AAAA-TQZZA 103
5.3.5.2 id
Table 105 id command
5.3.5.3 sdp
Table 106 sdp command
Description This command enables the context to configure criteria to monitor specific service SAP criteria.
Item Description
(2 of 2)
Item Description
Syntax id service-id
Context monitor>service
Description This command monitors statistics for a SDP binding associated with this service.
Item Description
Syntax sdp {sdp-id[:vc-id] | far-end ip-address} [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>service>id service-id
Description This command displays statistics for a specific service, specified by the service-id, at the
configured interval until the configured count is reached.
The first screen displays the current statistics related to the service-id. The subsequent
statistical information listed for each interval is displayed as a delta to the previous display.
When the keyword rate is specified, the “rate per second” for each statistic is displayed instead
of the delta.
Monitor commands are similar to show commands but only statistical information displays.
Monitor commands display the selected statistics according to the configured number of times
at the interval specified.
(1 of 2)