Tools
162
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
7.2.3.14 trap-suppress
Table 195 trap-suppress command
7.2.3.15 refresh-lsas
Table 196 refresh-lsas command
Parameters lsp lsp-name — Specifies the name that identifies the LSP. The LSP name can be up to 32
characters long and must be unique.
path path-name — Specifies the name for the LSP path up, to 32 characters in length.
Item Description
(2 of 2)
Item Description
Syntax trap-suppress [number-of-traps] [time-interval]
Context tools>perform>router>mpls
Description This command modifies thresholds for trap suppression.
Parameters number-of-traps — Specify the number of traps in multiples of 100. An error messages is
generated if an invalid value is entered.
Values: 100 — 1000
time-interval — Specify the timer interval in seconds.
Values: 1 — 300
Item Description
Syntax refresh-lsas [lsa-type] [area-id]
Context tools>perform>router>ospf
Description This command refreshes LSAs for OSPF.
Default None
Parameters lsa-type - Specify the LSA type using allow keywords.
Values: router, network, summary, asbr, extern, nssa, opaque
area-id - The OSPF area ID expressed in dotted decimal notation or as a 32-bit decimal integer.
Values: 0 — 4294967295
To Next Page
Loading...
