Nokia 7330 - Ntp; Polling-Rate; Server; Table 7 Ntp Command

System Management
30
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
3.5.1.3 ntp
Table 7 ntp command
3.5.1.4 polling-rate
Table 8 polling-rate command
3.5.1.5 server
Table 9 server command
Item Description
Syntax ntp
Context configure>system>time
Description This command enables the context to configure NTP client parameters. The ISAM can retrieve
its system time using the NTP protocol, with up to 5 NTP servers used.
Item Description
Syntax polling-rate polling-rate
Context configure>system>time>ntp
Description This command configures the polling rate.
Default 10
Parameters polling-rate — rate at which the servers are polled as a power of 2.
Item Description
Syntax server ip-address [server-port udp port]
no server ip-address
Context configure>system>time>ntp
Description This command configures the NTP server. Up to 5 NTP servers can be configured.
The no form of the command removes the server from the NTP server list.
Parameters ip-address — Specifies the IP address of the NTP server.
Parameters server-port — Specifies the UDP port on which the NTP server receives packets.