Nokia 7330 - Fec; Instance; Table 146 Fec Command; Table 147 Instance Command

Tools
144
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
7.2.2.13 fec
Table 146 fec command
7.2.2.14 instance
Table 147 instance command
Item Description
Syntax fec prefixip-prefix/mask
fec vc-type {ethernet | vlan} vc-id vc-id
Context tools>dump>router>ldp
Description This command displays information for an LDP FEC.
Parameters prefix ip-prefix/mask — Specifies the IP prefix and host bits.
Values host bits: must be 0
mask: 0 — 32
vc-type — Specifies the VC type signaled for the spoke or mesh binding to the far end of an
SDP.
The VC type is a 15 bit-quantity containing a value which represents the type of VC. The actual
signaling of the VC type depends on the signaling parameter defined for the SDP. If signaling
is disabled, the vc-type command can still be used to define the dot1q value expected by the
far end provider equipment. A change of the binding’s VC type causes the binding to signal the
new VC type to the far end when signaling is enabled.
VC types are derived according to IETF draft-martini-l2circuit-trans-mpls.
• Ethernet — The VC type value for Ethernet is 0x0005.
• VLAN — The VC type value for an Ethernet VLAN is 0x0004.
vc-id vc-id — Specifies the virtual circuit identifier.
Values 1 — 4294967295
Item Description
Syntax instance
Context tools>dump>router>ldp
Description This command displays information for an LDP instance.