Nokia 7330 - Cpu-Filter Ipv6-Filter; Keychain; Table 87 Cpu-Filter Ipv6-Filter Command; Table 88 Keychain Command

Security
76
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
4.4.4.2 cpu-filter ipv6-filter
Table 87 cpu-filter ipv6-filter command
4.4.4.3 keychain
Table 88 keychain command
Item Description
Syntax cpu-filter ipv6-filter [entry entry-id]
Context show>system>security
Description This command displays a single filter or a summary of all filters. In the case that entryId is not
specified, the output consists of a list of all CPU filters.
It has support for drop/forward counters. But it counts both control-plane and data-traffic due
to a limitation on hardware, while a specified action is only applied to control-plane traffic. So
these counters are not accurate. But if it needs to be reset for fresh monitor of any control-plane
traffic, this can be done by specifying shut/no shut on ipv6-filter so that the counters on all ipv6
entries will be reset.
Parameters entry-id — Specifies the CPU filter policy ID number.
Values: 1 — 65535
Item Description
Syntax keychain [key-chain] [detail]
Context show>system>security
Description This command displays keychain information.
Parameters key-chain — Specifies the keychain name to display.
detail — Displays detailed keychain information.