Nokia 7330 - 3.5 System Management CLI Commands; System Information Commands; Lacp-Priority; Time

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
System Management
Issue: 10 3HH-11982-AAAA-TQZZA 29
3.5 System Management CLI Commands
The following commands are described below:
• System Information Commands
• System Administration Commands
• Show Commands
• Clear Commands
3.5.1 System Information Commands
3.5.1.1 lacp-priority
Table 5 lacp-priority command
3.5.1.2 time
Table 6 time command
Item Description
Syntax lacp-priority lacp-priority
no lacp-priority
Context configure>system
Description This command configures the Link Aggregation Control Protocol (LACP) system priority on
aggregated Ethernet interfaces. LACP allows the operator to aggregate multiple physical
interfaces to form one logical interface
Default 32768
Parameters lacp-priority — Specifies the LACP system priority.
Values: 1 — 65535
Item Description
Syntax time
Context configure>system
Description This command enables the context to configure time parameters.