Nokia 7330 - Keychain Commands; Keychain; Direction; Table 73 Keychain Command

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Security
Issue: 10 3HH-11982-AAAA-TQZZA 69
4.4.3 Keychain Commands
4.4.3.1 keychain
Table 73 keychain command
4.4.3.2 direction
Table 74 direction command
Parameters old-entry-id — Enter the entry number of an existing entry.
Values: 1 — 1536
new-entry-id — Enter the new entry-number to be assigned to the old entry.
Values: 1 — 1536
Item Description
(2 of 2)
Item Description
Syntax [no] keychain keychain-name
Context configure>system>security
Description This command enables the context to configure keychain parameters. A keychain must be
configured on the system before it can be applied to a session.
The no form of the command removes the keychain nodal context and everything under it from
the configuration. If the keychain to be removed is in use when the no keychain command is
entered, the command will not be accepted and an error indicating that the keychain is in use
will be printed.
Default None
Parameters keychain-name — Specifies a keychain name which identifies this particular keychain entry.
Values: An ASCII string up to 32 characters.
Item Description
Syntax direction
Context configure>system>security>keychain
Description This command specifies the data type that indicates the TCP stream direction to apply the
keychain.
Default None