"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Tools
Issue: 10 3HH-11982-AAAA-TQZZA 161
7.2.3.12 cspf
Table 193 cspf command
7.2.3.13 resignal
Table 194 resignal command
Item Description
Syntax cspf to ip-addr [from ip-addr] [bandwidth bandwidth] [include-bitmap bitmap]
[exclude-bitmap bitmap] [hop-limit limit]
[exclude-address excl-addr [excl-addr ...(up to 8 max)]]
[srlg-group grp-id...(up to 8 max)]
Context tools>perform>router>mpls
Description This command enables the context to perform specific MPLS tasks.
Parameters to ip-addr — Specify the destination IP address.
Value: IP address (a.b.c.d)
from ip-addr — Specify the originating IP address.
Value: IP address (a.b.c.d)
bandwidth bandwidth — Specifies the amount of bandwidth in mega-bits per second (Mbps)
to be reserved.
Value: 1 — 100000
include-bitmap bitmap — Specifies to include a bit-map that specifies a list of admin groups
that should be included during setup.
Value: 0 — 4294967295 (accepted in decimal, hex (0x) or binary (0b))
exclude-bitmap bitmap — Specifies to exclude a bit-map that specifies a list of admin groups
that should be included during setup.
Value: 0 — 4294967295 (accepted in decimal, hex (0x) or binary (0b))
hop-limit limit — Specifies the total number of hops a detour LSP can take before merging
back onto the main LSP path.
Value: 1 — 255
exclude-address excl-addr — Specifies an IP address to exclude from the operation.
Value: IP address (a.b.c.d) (system or egress IP address)
srlg-group grp-id — Specifies the group ID.
Value: 0 — 4294967295
Item Description
Syntax resignal lsp lsp-name path path-name
Context tools>perform>router>mpls
Description Use this command to resignal a specific LSP path.
(1 of 2)
To Next Page
Loading...
