Nokia 7705 SAR - Page 269

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 269
lmi-type ansi
mode dte
n393dce 4
n393dte 4
n391dte 6
n392dce 3
n392dte 3
t391dte 10
t392dce 15
exit
exit
exit
line-impedance 120
exit
no shutdown
----------------------------------------------
*A:ALU-A>config>port#
Use the following CLI syntax to configure frame relay parameters for TDM DS3/E3
ports.
CLI Syntax: port port-id
tdm
ds3
encap-type {atm |bcp-null | bcp-dot1q |
ipcp | ppp-auto | frame-relay |
wan-mirror | cem}
mode {access | network}
frame-relay
lmi-type {ansi | itu | none | rev1}
mode {dce | dte | bidir}
n393dce count
n393dte count
n391dte intervals
n392dce threshold
n392dte threshold
t391dte keepalive
t392dce keepalive
no shutdown
exit
no shutdown
exit
exit
no shutdown
e3
encap-type {atm | bcp-null | bcp-dot1q |
ipcp | ppp-auto | frame-relay |
wan-mirror | cem}
mode {access | network}
frame-relay
lmi-type {ansi | itu | none | rev1}
mode {dce | dte | bidir}