Nokia 7705 SAR - Page 328

7705 SAR Interfaces
328
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Description This command specifies the QoS policy parameters for ring traffic in a network, for the 2-port
10GigE (Ethernet) Adapter card or 2-port 10GigE (Ethernet) module.
add-drop-port-queue-policy
Syntax add-drop-port-queue-policy name
no add-drop-port-queue-policy
Context config>card>mda>network>ring
Description This command specifies the network queue policy to be applied to the add/drop port on the
bridging domain side of a ring adapter card. The network queue policy is defined in the
config>qos>network-queue context. Refer to the 7705 SAR Quality of Service Guide,
“Network Queue QoS Policies”, for more information.
The ring ports and the add/drop port cannot use the same non-default network queue policy
that is being used by the v-port and any other port on other cards.
Default no add-drop-port-queue-policy
Parameters name — specifies an existing network queue policy
qos-policy
Syntax qos-policy network-policy-id
no qos-policy
Context config>card>mda>network>ring
Description This command specifies the network QoS policy for the ring. Only a ring type network QoS
policy can be assigned to a port on the bridging domain side of a ring adapter card.
Default no qos-policy
Parameters network-policy-id — specifies the network QoS policy for the ring ports and the add/drop
port on a ring adapter card
spt
Syntax spt
Context config>card>mda
config>system
Description This command enables the context for configuring SPT (self-processed traffic) parameters.
The config>card>mda context is used for the 7705 SAR-8, 7705 SAR-18, and 7705 SAR-X.
The config>system context is used for the 7705 SAR-Hc, 7705 SAR-H, and 7705 SAR-Wx.