Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 327
shaper-policy
Syntax shaper-policy policy-name
no shaper-policy policy-name
Context config>card>mda>access>ingress
Description This command enables the context to assign a shaper policy to an Ethernet MDA.
For access ingress per-customer aggregate shaping, the shaper policy is assigned to an
Ethernet MDA and SAPs on that Ethernet MDA must be bound to a shaper group within the
shaper policy bound to that Ethernet MDA.
The default shaper policy cannot be deleted. Table 24 displays the default shaper policy
parameters.
The no form of this command removes the configured shaper-policy.
Default shaper-policy “default”
Parameters policy-name — the name of the shaper policy. To access the default shaper policy, enter
“default”.
Values Valid names consist of any string up to 32 characters long
composed of printable, 7-bit ASCII characters.
If the string contains special characters (#, $, spaces, etc.), the
entire string must be enclosed within double quotes.
create — keyword used to create a shaper policy
ring
Syntax ring
Context config>card>mda>network
Table 24 Shaper Policy Defaults
Field Default
description “Default Shaper QoS policy.”
shaper-group “default”
description “Default Shaper Group.”
pir-rate max
cir-rate 0
To Next Page
Loading...
