Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 2-107 P/N 196515 (Revision A)
Lesson 2-12
Needle Sensor
A. Introduction
The needle sensor locates the XYZ position of the needle. It is also used to
determine the XYZ location of the Height Sensor Probe in relation to the needle.
These locations are sent to the dispensing software, which uses them during the
programming process and during production runs.
B. Enabling Objective
2.12 Perform the necessary procedures to configure and verify the functionality
of the needle sensor.
C. Topic Outline
1. Introduction
2. Overview
 Needle Sensor
 Theory of Operation
 Needle Sensor Setup
3. Summary and Review
To Next Page
Loading...
Need help?
General