Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 5-25 P/N 196515 (Revision A)
Lesson 5-5
Removing and Replacing the Dispensing Head
A. Introduction
The valve, camera, and the optional height sensor, needle heater, and low fluid
sensor are connected to the Dispensing Head Assembly. The following lesson
outlines the procedure to remove and replace the Dispensing Head if it is
determined to be faulty.
B. Enabling Objective
5.5 Perform the procedure to remove and replace the Dispensing Head.
C. Topic Outline
1. Introduction
2. Overview
 Removing the Dispensing Head
 Installing the Dispensing Head
3. Summary and Review
To Next Page
Loading...
Need help?
General