Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 4-39 P/N 196515 (Revision A)
Lesson 4-4
Troubleshooting XY-Axis Motion
A. Introduction
Occasionally, you may experience problems with dispense head motion. This can
occur for a variety of reasons. The service technician should be able to isolate
the reasons for the problems and perform corrective action as necessary.
B. Enabling Objectives
4.4 Identify possible causes of and solutions to XY-axis motion failure.
C. Topic Outline
1. Introduction
2. Overview
XY-Axis Motion Fault Isolation Procedure
XY Servo Amplifier Fault Isolation
XY-Axis Motion Troubleshooting Summary
Troubleshooting Guidelines
3. Summary and Review
To Next Page
Loading...
