Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 3-34 P/N 196515 (Revision A)
Information Sheet 3-7-1
Cleaning and Replacing Conveyor Belts
A. Conveyor Belt Maintenance
1. To maintain optimum system performance, it is recommended that you
change the conveyor belts every six months.
2. Belts may need to be changed more frequently or less frequently, depending
upon the volume of part handling.
3. Belts should be replaced if they are cracked, worn or broken.
B. Cleaning the Belts
1. Clear the Conveyor of all boards or carriers.
2. Open the Hatch and manually move the Dispensing Head to the back of the
dispensing area.
3. Wipe the length of each conveyor belt with isopropyl alcohol and a soft cloth.
4. Using an MSDS recommended solvent and a soft cloth, clean any wet or dry
fluid that may have spilled on the Conveyor rails.
5. Close the Hatch.
To Next Page
Loading...
Need help?
General