Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 2-159 P/N 196515 (Revision A)
Lesson 2-18
PMAC Plot
A. Introduction
One of the diagnostic tools available is a built-in tool called PMAC Plot. PMAC Plot
is used to measure and gather position, velocity and acceleration profiles of the
dispense head for dispensing programs written in FmNT that are installed on
Asymtek servo systems. By analyzing this information, service personnel can
determine if the equipment is functioning properly, thereby narrowing the focus
of the troubleshooting effort.
B. Enabling Objective
2.18 Demonstrate the ability to gather and interpret PMAC Plot data.
C. Topic Outline
1. Introduction
2. Overview
 PMAC Plot
 Gathering Data
 Plotting Data
 Analyzing Data
 Saving and Printing Data
3. Summary and Review
To Next Page
Loading...
Need help?
General