Olivetti PR2 - Page 61

Service Manual
683311W
4-9
Selects (Y) or (N) for automatic line feed (LF) at every
carriage return command received (CR).
Enables/disables the printing of slashed zero.
Selects the maximum length of the printed line as a
number of characters (10 cpi).
Selects the maximum length of processable
documents in inches.
Selects the type of page bottom margin (BOF) for the
processed document. If the parameter is Y, the bottom
margin is 13.7 mm; if the parameter is N the margin is
4.23 mm.
Selects the type of page top margin (TOF) for the
processed document. If the parameter is Y, the top
margin is 4.23 mm for documents and 7.4 mm for
passbooks; if the parameter is N, the margin is between
4.3 and 30 mm (defined by the set-up described in
section 4.4.1) for documents and 7.4 mm for passbook.
Selecting (Y) allows access to the PNS selection
menu in the IBM environment.
Enables the ESC' (n) command for passbook (n=D or
E or F or G) or document (n=@ or A or B or C)
selection.
If enabled upon reception of a Form Feed, the
document is ejected.
Enables the supplementary identifier esc bell W.
Logical reset ESC @
Selects a 1/5" spacing
Stores (Y) or not (N) the arrangement selected in this
set-up section.
CR+ LF Y - N
ZERO SLASH N - Y
LINE LENGTH 80 - 90
FORM LENGTH 11 - 12
BOTTOM Y - N
MARGIN
IBM-PP LIKE
TOP MARGIN Y - N
IBM-PP LIKE
PNS SELECTION: N - Y
PNS SELECTION: N - Y
PNS # 3519: N - Y
PNS # 4192: N - Y
PNS # 4411: N - Y
PNS # 4501: N - Y
SAVE PARAMETERS Y - N