Service Manual
683311W
3-15
3.7.6.2 REPLACING THE RIBBON CARTRIDGE WITH THE MACHINE POWERED ON
The ribbon cartridge can be changed with the machine powered on and by following the procedure
listed below:
- Open the printer cover. Printing stops automatically.
- Lift the upper assembly by using the appropriate lever.
- Remove the used cartridge and replace it with a new one, as previously described.
- Lower the upper assembly by using the apropriate lever.
- Close the printer cover
Note: DO NOT manually move the printhead.
3.7.7 PAPER JAMS
Paper could become jammed along the internal path of the machine.
The jamming could be caused by one of the following:
- Paper path obstructed (residual paper for instance)
- Paper incorrectly fed
- Paper weight or size over the permitted limits
- Paper in bad condition: crumpled, deformed or in a bad state of preservation
- Paper with metal staples or paper clips (this can seriously damage the machine)
- Multicopy forms with badly glued sheets.
The areas where jamming is most likely to occur are:
A front document insertion slot
B inside the printer
C rear document output slot
To Next Page
Loading...
