Olympus RollerFORM - Page 165

DMTA-20073-01EN, Rev. C, November 2015
Index 159
primary location 121
recalibration 134
location
alternate 118, 125
primary 110, 121
rating label
location 1, 2
symbols 3
relocating
alternate encoder holder, installation on
125
alternate encoder holder, removal from 118
primary encoder holder, installation on 121
primary encoder holder, removal from 125
retaining screw, not to overtighten 117, 130
spring, sufficient tension 123, 134
modes, inspection 31
modes, scan
bidirectional 32
scan overlap 35
unidirectional 31
recommended 31
modification prohibited, instrument 7
modification, instrument 7
MSDS (material safety data sheet) 9
N
NOTE signal word 9
notes, information
signal words 9
nozzle, manual pump 24, 26
O
Olympus technical support 13
OmniScan connector
cable, minimal length outside sheath 29, 84
connection to instrument 29
OmniScan MX, adaptor usage 30, 140
OmniScan PA series
connection 29
Indexer Clicker, setup 33
setup 31
Start Acquisition button, setup 36
On/Off button, laser guide 66, 70
location 19, 66
opacification, tire 65, 90
acoustic properties, conservation 90
preventative procedure 90
transparency restoration 92
overview, RollerFORM 17
P
parts, spare See spare parts
phantom spots, presence of 7
phased array probe See probe-axle
pinouts, OmniScan MX2 scanner interface con-
nector 140
piston, manual pump 24, 26
pliers, retaining C-clip 17, 79, 81
precautions
safety 9
primary encoder holder 110
probe angle adjustment knob
location 19
probe-axle rotation, always with ~ 51
probe element direction indicator, first to last 64
probe, phased array See probe-axle
probe-axle
See also C-clip
angle, adjustment 50
with angle adjustment knob 51
beam effective width 60
change 77
first to last element direction indicator 64
indicators
active aperture position 64
first to last element direction 64
installation, in acoustic wheel 80
probe cable, never use to rotate probe-axle 51
removal, from acoustic wheel 77
signal, optimization 50
prohibited modification, instrument 7
Propylene Glycol Dynalene PG 41, 75, 86
pump, manual See manual pump
R
rating labels
Mini-Wheel encoder
location 1, 2
symbols 3
RollerFORM
locations 1