124
Wiring and Connections Section 4-7
Wiring and Assembly The following illustrations show the procedure for wiring and assembly of sol-
der-type connectors. First pass the electrical wires through heat-shrinking
tubes and solder them to the socket pins.
After soldering all of the necessary pins, slide the heat-shrinking tubes over
the soldered areas of the respective wires. Then shrink the tubes by heating
them with a jet of hot air.
Finally, assemble the socket and connector cover as shown below.
Heat-shrinking tube
Electrical wire
Connector
Heat-shrinking tube
Connector cover
Small screws (3)
Small screws (2)
Socket
Nuts (3)
Nuts (2)
Connector lock screw
Cable clamp
To Next Page
Loading...
