42
Overview Application Procedure Section 1-6
4. Assemble the PC.
5. Turn ON the power supply.
6. Write the ladder program.
7. Transfer the program to the CPU Unit.
8. Test operation.
The following steps must be performed in trial operation.
a) Check I/O wiring.
b) Set the required bits in memory (such as the I/O Hold Bit).
c) Monitor operation and debug the system in MONITOR Mode.
9. Correct the program and return to step 7., above.
10. Store/print the program.
11. Begin actual operation.
To Next Page
Loading...
