Configuring the Run Mode Display
FQ-CR2 User’s Manual
63
6
Operation
Specifying the Startup Run Mode Display
The display that appears when power supply is turned ON can be set.
The default setting is [Graphics].
(Setup Mode or Run Mode) − [TF settings] − [Startup display] − [Display pattern]
Displaying the Inspection Item Results
You can scroll though the measurement results of all the configured inspection items by using the following
operations.
You can set the scene to be displayed when the power supply is turned ON.
Setting the Startup Scene: p. 71
The following are also displayed in addition to the measurement results for each inspection item.
• Camera input: The image that is being measured is displayed.
• Filter: Shows the image after filter processing.
Switches to the next
inspection item.
Switches to the previous inspection item.
FQ Sensor User Manual.book 63 ページ ２０１１年７月８日 金曜日 午後２時３０分
To Next Page
Loading...
