3-1
Connecting with a Vision Sensor
To establish an online connection with FH/FHV vision sensor, configure settings and make adjust-
ments, connect directly by Ethernet.
You can also connect via a hub or router.
It is not possible to set and adjust FH/FHV vision sensor via NJ/NX/NY-series Controller.
Precautions for Correct Use
• If there is already a different FH/FHV slave device in the project with an established online
connection, you will not be able to establish an online connection for a new FH/FHV slave
device. First, switch the other FH/FHV slave device from online to of
fline.
• Do not start the Remote Operation tool while using Sysmac Studio.
• To configure account settings with an FH/FHV vision sensor, you will need to log in to your
account while online.
For details on logging in to your account, refer to 3-6 Logging in to a Registered User's Ac-
count on page 3 - 11.
3 Connecting with a Vision Sensor
3 - 2
FH/FHV Series Vision System Operation Manual for Sysmac Studio (Z343-E1)
To Next Page
Loading...
