Omron SYSMAC FH Series

2-2
Basic Design Flow 2
This section describes the flow for designing a system that uses a controller other than NJ/NX/NY-ser-
ies CPU Unit.
New project settings
Create a project file.
(1) Starting Sysmac Studio
Start Sysmac Studio.
For details, refer to Starting and Exiting the Sysmac Studio in the Sysmac Studio Version 1
Operation Manual (Cat. No. W504).
(2) Designing a new project
Create a new project.
Select a vision sensor for the category and FH/FHV for the device.
For details, refer to 2-3 Creating a New Project on page 2 - 7.
(3) Selecting sensor type
Select the sensor type and then establish an online connection.
For details, refer to the step 3 on 2-3-1 Creating a New Project File from the Project Window on
page 2 - 7.
Sensor configuration and settings
• Sensor configuration:
(1) Creating an interface configuration for the sensor
Edit the interface configuration.
For details, refer to 5-2 Setting Procedure on page 5 - 3.
• Sensor settings:
(1) Editing the communication conditions
Edit the communication conditions of the sensor.
For details, refer to 5-2 Setting Procedure on page 5 - 3.
Design
Create the processing flow.
(1) Creating flow
For details, refer to 2-6 Basic Operations of Flow Editing on page 2 - 35.
(2) Editing processing units
For details, refer to 4-2 Editing a Processing Unit on page 4 - 5.
Online debugging of sensor
Perform debugging using the actual device.
2 Basic Operations
2 - 5
FH/FHV Series Vision System Operation Manual for Sysmac Studio (Z343-E1)
2-2 Basic Design Flow 2
2