Workstation 5A Setup Guide - Fourth Edition 5-5
WS5A Diagnostics
Workstation 5A Diagnostics Utility
Diagnostics Version
This field displays the WS5A Diagnostics Utility Software version.
Version 1.5 is part of the GR1.5 documented in this edition.
Workstation Model
This field is new to WS5A Diagnostics to distinguish it from the
Workstation 5.
Hardware Revision
This field displays the Workstation 5A System Board hardware revision.
Revision D is currently shipping.
RAM Space Available
This field displays the amount of available RAM.
Physical Address
This field displays the network Media Access Control (MAC) number
assigned to the system board Ethernet Controller. Each workstation will
display a unique value in this field.
DHCP Server Address
This field displays the DHCP Server Address when the workstation
operates in DHCP based network.
IP Address (Dynamic)
This field displays the IP Address when the workstation operates in DHCP
or Static IP mode.
Motherboard Serial
This field displays the Workstation 5A System Board Serial Number.
USB Flash Drive Size
This field displays the USB Hard Drive size. For Windows Embedded CE
6.0 the device contains three partitions of roughly equal size. However,
since only the \DOC partition is visible in Windows CE, this field reports
about 1/3 of the total size of the device. For example, if a 256MB USB
Hard Drive is installed, this field displays 80MB - roughly one third of the
total size. When a 512M USB Hard Drive is installed, each partition is
about 178MB.
The POS Ready 2009 configuration currently uses a 4GB USB Hard Drive
with a single partition and will update to an 8GB USB Hard Drive.
To Next Page
Loading...
Need help?
General
