Enable and Verify Newly Installed DIMMs
g.
Switch to the system console and type the Oracle Solaris fmadm faulty
command.
# fmadm faulty
If any faults are reported, refer to the diagnostics instructions described in “Check for
Faults” on page 46.
5.
Switch to the Oracle ILOM command shell.
6.
Run the show faulty command.
-> show faulty
Target | Property | Value
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0 | fru | /SYS/MB/CMP0/MR1/BOB1/CH0/D0
/SP/faultmgmt/0 | timestamp | Dec 14 22:43:59
/SP/faultmgmt/0/ | sunw-msg-id | SUN4V-8000-DX
faults/0 | |
/SP/faultmgmt/0/ | uuid | 3aa7c854-9667-e176-efe5-e487e520
faults/0 | | 7a8a
/SP/faultmgmt/0/ | timestamp | Dec 14 22:43:59
faults/0 | |
If the show faulty command reports a fault with a UUID go to Step 7. If show faulty does not
report a fault with a UUID, you are done with the verification process.
7.
Switch to the system console and type the fmadm repair command with the UUID.
Use the same UUID that was displayed from the output of the Oracle ILOM show faulty
command.
# fmadm repair 3aa7c854-9667-e176-efe5-e487e520
Servicing Memory Risers and DIMMs 111
To Next Page
Loading...
Need help?
General