Copyright© Orphée SA. All Rights Reserved.
2. GENERAL OVERVIEW
2.1 GENERALITIES
The MYTHIC 22 is an automated hematology analyzer for in vitro diagnostic use in clinical laboratories by an
authorized and trained people.
- Only human blood or artificial blood (recommended ORPHEE controls or calibrators) should be run.
- Only the reagents mentioned in this manual are permitted to be used.
- The optimum performances can be only achieved if the calibration, controls check, cleaning and
maintenance procedures are carefully followed (see section 9.1).
MYTHIC 22 is a fully automated analyzer performing hematological analysis on whole blood collected on
EDTA K2 or K3 tubes.
- Sample volume: 15,7 µl (inside the needle, the total volume could be upper in function of the blood
remaining outside of the needle).
- Throughput: > 45 samples/hour.
- 24 analysis parameters in DIF mode and 12 parameters in CBC mode:
Leukocyte parameters:
WBC White Blood Cells
LYM Lymphocytes in % (DIF mode only)
LYM Lymphocytes in # (DIF mode only)
MON Monocytes in % (DIF mode only)
MON Monocytes in # (DIF mode only)
NEU Neutrophils in % (DIF mode only)
NEU Neutrophils in # (DIF mode only)
EOS Eosinophils in % (DIF mode only)
EOS Eosinophils in # (DIF mode only)
BAS Basophiles in % (DIF mode only)
BAS Basophiles in # (DIF mode only)
Erythrocyte parameters:
RBC Red Blood Cells
HGB Hemoglobin
HCT Hematocrit
MCV Mean Corpuscular Volume
MCH Mean Corpuscular Hemoglobin
MCHC Mean Corpuscular Hemoglobin Concentration
RDWC Red Blood cells Distribution Width (CV)
RDWS Red Blood cells Distribution Width (SD)
Thrombocyte parameters:
PLT Platelet
MPV Mean Platelet Volume
PDW* Platelet Distribution Width
PCT* Thrombocrit
PLCR* Platelet Large Cell Ratio
* For Investigation Use only in United States of America.
To Next Page
Loading...