Orphee mythic 22 - Sample Run

To Next Page

To Previous Page

5. SAMPLE ANALYSIS

REF : M22/UM/EN/014

Page 54/105

MYTHIC 22

5.6.3 Sample run

Wear rubber gloves before starting and wash hands with a disinfectant after completion of

work.

NOTA: The needle will be available as soon as the idle temperature is reached (about 15 minutes at 23°C of

room temperature).

This prompt

means that the temperature setting of the enclosure and/or the

reagent is not reached yet.

This prompt means that the temperature setting of the enclosure and/or the

reagent is reached and that a cycle can be run.

As soon as the temperature is reached, a measurement cycle can be run

- If the needle is not visible first press on the start cycle trigger and wait

for the descent of the needle.

Present the tube of the blood sample under the needle and press the start

cycle trigger.

- The cycle LED

located at the top of the needle becomes red the tube

can be removed only when the needle is up.

- A new cycle can be started again when it turns by green again.

- As soon as the cycle is launched, the SID is incremented automatically and,

thanks to its data processing multitasks, the MYTHIC 22 is available for the

identification of the following sample (See section 5.6.2).

Start cycle

trigger