Copyright© Orphée SA. All Rights Reserved.
5.6 ANALYSIS
5.6.1 Introduction
It is recommended (Sometimes mandatory according to the local legislation) to carry out a
Quality Control (QC) once a day and a calibration if necessary (see section 6 & 7).
Read the analytical limitations (see section 4.4) before run the sample.
The working temperature of the fluidic part must be reached before starting the analysis.
The average time to reach it is around 15’ at a room temperature > 23 °C (see 5.6.3).
NOTA: The MYTHIC 22 is delivered with a standard parameter setting described in section 3.
5.6.2 Sample Identification
- From the main menu, press to reach the analysis
display.
- This prompt appears when the results memory is almost full. To avoid this
message, select the option FIFO mode in the set up.
- This prompt appears when the results memory is totally full.
- To delete results see section 5.10 .
To Next Page
Loading...