Orphee mythic 22 - Troubleshooting Messages

REF : M22/UM/EN/014
9. SERVICE
MYTHIC 22
Copyright© Orphée SA. All Rights Reserved.
Page 99/105
9.6 TROUBLESHOOTING MESSAGES
This section allows knowing what to do when a troubleshooting message appears on the screen.
If the problem persists; go on contact your Orphee representative.
MESSAGE
ACTION
SYSTEM: FATAL ERROR
Re-start the Mythic. Update to last SW version if not done.
SYSTEM: INTERNAL TIME OUT
Re-start the Mythic. Update to last SW version if not done.
CYCLE: BUSY
Wait before performing a cycle.
CYCLE STOPPED BY USER
Emergency stop, please perform a control cycle.
CYCLE: EMERGENCY STOP
Perform a control cycle.
CYCLE: CMD VALVE FAILED
Change the valve or check cable connection.
CYCLE: VALVE XX FAILED
Change the valve XX or check related cable connection.
CYCLE: INIT NOT DONE
Perform an initialization or a control cycle.
OUT OF RANGE
Modify the value.
MECA: MOTOR NEEDLE BUSY
Re-start the Mythic.
MECA: MOTOR SYRINGE BUSY
Re-start the Mythic.
MECA: MOTOR ROCKER BUSY
Re-start the Mythic.
MECA: HOME NEEDLE NOT FOUND
Perform an initialization or a control cycle. Check greasing.
MECA: HOME SYRINGE NOT FOUND
Perform an initialization or a control cycle. Check greasing.
MECA: HOME ROCKER NOT FOUND
Perform an initialization or a control cycle. Check greasing.
MECA: MOTOR NEEDLE GAP
Check greasing. Check needle belt mechanic tension.
MECA: MOTOR SYRINGE GAP
Check greasing. Check waste tubing.
MECA: MOTOR ROCKER GAP
Check greasing. Check white motor wheel state.
MECA: NEEDLE NOT IN TOP POSITION
Perform a control cycle. Check needle sensor/cable sensor.
CONTROL CYCLE NOT DONE
Perform a control cycle.
START UP CYCLE NOT DONE
Perform a startup cycle.
RINSE NOT DONE
Perform a clean cycle.
CLEAN NOT DONE
Perform a rinse cycle. Rinse baths.
STARTUP CYCLE FAILED
Perform a new start up cycle.
CYCLE: FLUIDIC DOOR OPENED
Close the Fluidic door. Run Control cycle.
INTERN: COUNT ERROR
Re-start the Mythic. Update to last SW version if not done.
RUNNING AUTO CLEANING
Press OK.
DILUENT ALMOST EMPTY
Replace the container and perform a prime Diluent.
LYSE ALMOST EMPTY
Replace the bottle and perform a prime Lyse.
CLEANER ALMOST EMPTY
Replace the bottle and perform a prime Cleaner.
WASTE ALMOST FULL
Replace the waste container. Reset waste counter.
THE DILUENT USED IS OUT OF DATE
Replace the container and perform a prime Diluent.
THE LYSE USED IS OUT OF DATE
Replace the bottle and perform a prime Lyse.
THE CLEANER USED IS OUT OF DATE
Replace the bottle and perform a prime Cleaner.
SYSTEM: EEPROM COM ERROR
Wait before performing a cycle. If persisting, re-start the
Mythic. Update to last SW version if not done.
INIT PRINTER
Switch on the printer or invalidate the printings.
NO PRINTER SELECTED
Switch on the printer or invalidate the printings.