Orphee mythic 22 - Piston Greasing

To Next Page

To Previous Page

9. SERVICE

REF : M22/UM/EN/014

Page 86/105

MYTHIC 22

- Wait for the information window and then,

- Open the door on the right hand

side (see

section 1.1.3).

- Put 4 ml of Mythic 18-22 FLUSH - CLEANER

(Ref. HM18-011-025) in each counting chamber

, close

the side door.

- Press the button in the window l

ocated in the screen

center.

- MYTHIC 22

perform a maintenance cycle of the

apertures followed with a standby mode during 10 min.

- After 10 min. MYTHIC 22 rinses all of the elements.

Perform a blank cycle before to run

any

analytic cycle.

Wear rubber gloves and wash hands with a

disinfectant after completion of work.

9.1.3 Piston greasing

This simple operation keeps the state of the pistons and the pistons o-rings in perfect state which

allow extending the lifetime between the pistons o-rings exchange.

- To have access to the hydraulic cycle, press from the

MAIN MENU, then press .

Press to put the piston of the syringe module in the

greasing position.

To avoid any risk of injuries, w

ait complete end of piston

movement before to perform the greasing.

NOTA

: The greasing frequency must be increased proportionally to the daily

workload (see maintenance table 9.1.1).