Copyright© Orphée SA. All Rights Reserved.
Wear rubber gloves and wash hands with a
disinfectant after completion of work.
- Wait for the information window and then,
- Open the door on the right side (see section 1.1.3).
- Put a small nut of grease (part 410-0501-01) on a finger.
- Put a thin film of grease around each piston.
- Turn the
two big pistons (waste pistons) with the help of the
key supplied in the installation kit.
- Continue to put a thin film of grease around each piston.
- The other pistons can be turned with fingers.
- Press CONTINUE.
- Close the side door.
9.2 HYDRAULIC CYCLES
- To have access to the hydraulic cycle, press from
the MAIN MENU, then press .
To Next Page
Loading...