Handbook
November 2011 / 59-UMC0071 / Issue 01
Mercury iTC
Page 107
COMMAND REFERENCE GUIDE
Original Instructions
A SIG is returned as a value, followed by the scale.
Scale is of the form:
n# - nano
u# - micro
m# - milli
# - none
#k - kilo
#M - mega
where # is replaced by the relevant SI units, for example:
A - Amps
V - Volts
W - Watts
10.3.4.1 System commands
System commands are used for system-level settings.
SYS system designator N/A
TIME time in the 24 hour clock Read/Set hh:mm:ss
DATE date Read/Set yyyy:mm:dd
MAN manufacturing designator N/A
HVER hardware version Read only version number
FVER firmware version (GUI/APP) Read only version number
SERL unit serial number Read only alphanumeric
MODE mode of operation [NORM | ENG] Read/Set enumerated value
PASS engineering mode password Set alphanumeric.
Required to enter
ENG mode.
FLSH amount of free space in flash memory Read free space in kByte
DISP display designator N/A
DIMA auto dim on/off Read/Set OFF, ON
DIMT auto dim time Read/Set seconds
BRIG brightness Read/Set 10.0 to 100.0%
RST reset the system Set N/A
CAT catalogue Read
To Next Page
Loading...