Handbook
November 2011 / 59-UMC0071 / Issue 01
Mercury iTC
Page 92
BASIC OPERATING INSTRUCTIONS
Original Instructions
6.5.6 Enabling local control of the iTC
1 Tap Settings on the Home page.
2 Tap the Remote Access field and select Local from the drop-down menu.
1 Tap Apply to enable local control of the iTC.
6.6 Re-configuring sensors and heaters
6.6.1 To clear a panel configuration
1 Double-tap the panel on the Home page that is to be cleared.
2 Tap the Devices field and select None from the drop-down menu.
3 Tap Assign.
4 The panel on the Home page should now display the name None.
6.6.2 Re-configuring a sensor
1 Tap a configured panel on the Home page.
2 Edit the sensor details on the Sensor Details Screen page.
3 Tap Home to return to the Home page.
6.6.3 Re-configuring a heater
4 Tap Heater on the Home page.
5 Edit the displayed values for the heater that is to be re-configured.
6 Tap Home to return to the Home page.
6.6.4 Re-configuring a control loop
1 Tap Control on the Home page.
2 Edit the displayed values and settings on the Control Loop Configuration page as
required.
3 Tap Home to return to the Home page.
To Next Page
Loading...