Oxford Instruments Mercury iTC User Manual

Handbook
November 2011 / 59-UMC0071 / Issue 01
Mercury iTC
Page 47
USER INTERFACE
Original Instructions
3.2.12.4 Ethernet Settings tab
The page contains the following fields and controls:
 IP Address
If DCHP is set Off, enter the ip address that has been assigned to the iTC ethernet
connection.
 Subnet
If DCHP is set Off, enter the subnet mask that is to be used for the iTC ethernet
connection.
 Gateway
If DCHP is set Off, enter the gateway address that is to be used for the iTC ethernet
connection.
 DHCP
Select if DHCP is to be used or not. If DHCP is set to On, the iTC is automatically
assigned an ip address, subnet mask, and gateway from the network. If DHCP is set
to Off, the values entered in the IP Address, Subnet and Gateway fields are used.
 MAC Address
The MAC address of the iTC is displayed. This value is assigned at the factory and
cannot be edited.
The page contains the following buttons:
 Alarm
Tap once to access the Alarm Logs page (see Section 3.2.13).

Oxford Instruments Mercury iTC Specifications

General

Brand	Oxford Instruments
Model	Mercury iTC
Category	Controller
Language	English