Oxford Instruments Mercury iTC User Manual

Handbook
November 2011 / 59-UMC0071 / Issue 01
Mercury iTC
Page 79
GETTING STARTED
Original Instructions
5.3.2.4 Connecting the GPIB (if required)
1 Switch off electrical power to the iTC.
2 Switch off electrical power to all instruments and controllers that are connected to
the GPIB.
3 Connect the iTC to the bus using a standard GPIB cable.
5.3.3 Connecting the auxiliary port (if required)
Referring to Section 15.2.2, connect any required inputs or outputs to the port on the
auxiliary I/O daughter-board.
5.3.4 Connecting the level-meter (if required)
Referring to Section 16.2.2, connect a level-sensor to the relevant port on the level-
meter daughter-board.
Caution
CABLE DISCONNECTION
Do not connect or disconnect GPIB cables while the computer, or any of
the instruments, are powered up. Equipment damage can result if this
precaution is not observed.
DÉBRANCHEMENT DU CORDON
Ne pas brancher ou débrancher des cordons de bus d'interface général
pendant que l'ordinateur, ou n'importe lequel des instruments, est sous
tension. Ne pas respecter cette précaution risque d'endommager
l'équipement.

Oxford Instruments Mercury iTC Specifications

General

Brand	Oxford Instruments
Model	Mercury iTC
Category	Controller
Language	English