Handbook
November 2011 / 59-UMC0071 / Issue 01
Mercury iTC
Page 130
HEATER DAUGHTER BOARD
Original Instructions
7 Using appropriate ESD precautions, fit the heater board in the allocated expansion
slot.
8 Secure the board using the screw that was removed in step 6.
9 Refit the board-clamp, using the two screws that were removed earlier.
10 Fit the lid back onto the unit, using the screws that were removed earlier.
14.2.2 Connecting the heater
The heater is connected to the 9-way D-connector on the associated temperature
sensor board. Pin connections are listed in Section 4.2.4.
On a dual-sensor board the heater is only connected to the lower connector.
14.2.3 Configuring the heater board
See Section 5.4.3 for details.
14.2.4 Configuring the control loop.
See Section 5.4.4 for details.
To Next Page
Loading...
Need help?
General