Panasonic KX-NS1000 - Page 244

Feature Time Source
LPR Time Local PBX
PT idle time display Local PBX
PT Time format (12H/24H) Master Unit
PS idle time display Local PBX
PS note alarm Local PBX
Activation key expiration Master Unit
Error log Local PBX
SNMP, syslog Local PBX
File time stamp Local PBX
CTI applications (first and third party) Uses computer’s time
Time sent to UM Local PBX
UM time reading Uses UM’s time
*1
® 14.6 PBX Configuration—[6-6] Feature—Tenant
—
Time Service Mode
Conditions
[General]
• KX-NSN001 (Activation Key for One-look Network) is required for each PBX in the network to use this
feature.
• The types of PBXs that can be assigned as Master and Slave units are as follows:
– Master unit: KX-NS1000
– Slave unit: KX-NS1000
, KX-NS700
• A maximum of 15 Slave units can be registered to the Master unit.
• Tenants (® 19.1.2 Tenant Service) and ICD groups (® 10.1.1 ICD GROUP FEATURES) can contain
extensions from multiple sites, and therefore multiple time zones. For time-sensitive operations, such as
Time Service (® 19.1.3 Time Service), system programming determines which PBX’s clock is used for
determining the current time.
® 14.6 PBX Configuration—[6-6] Feature—Tenant—
Time Service Mode
• Due to hardware constraints, the following resources are not shared between sites:
– Echo canceller
– OGM
– BGM
– VoIP resources
– PS handover
– Network time synchronization signal
• The Master unit must be running for the One-look network to operate.
• It
is recommended that One-look networks be located in one country/area. Operation cannot be guaranteed
for One-look networks that span multiple countries/areas.
• For information about which types of PBXs are available to use as Slave units in your country/area, consult
your dealer.
244 Feature Manual Document Version 2016-03
14.1.4 One-look Network