Parker 690+ series - Page 11

Programming Your Application 1-3
690+ Series Frequency Inverter
Any Configurable “Destination” Parameter
A similar process can be used to apply or edit a link to any configurable parameter that is to be
the intended “destination”. The process selects the “source” for the link.
Note: It is possible for several “destination” parameters to share the same “source”.
menu at level 4
M
TAG
NULL

VALUE
FALSE


VALUE
SOURCE
DIGITAL OUTPUT 3
M
HOLD FOR 3 SECONDS FOR
QUICK TAG INFORMATION
737
M
PRESS AGAIN FOR
QUICK LINK INFORMATION
"UP" TO CONFIRM
ENABLE CONFIG
M
NULL
SOURCE
ALL LEDS BEGIN FLASHING
CONFIRMING CONFIG MODE
READY
SOURCE
E
SEQUENCING LOGIC/READY
SOURCE
E
PRESS REPEATEDLY UNTIL THE
WELCOME SCREEN IS DISPLAYED
5.5kW 400V V1.1
AC MOTOR DRIVE
for example
E
5.5kW 400V V1.1
AC MOTOR DRIVE
"CONFIG MODE LOCKED"
DISPLAY SHOWS THE SELECTED SOURCE
M
NAVIGATE THE MENU SYSTEM
TO SELECT THE NEW SOURCE
Alternates between "block name"
and "parameter"