Parker 690+ series User Manual

605 Frequency Inverter/HA389591/Issue 1
Contents
Contents Page
Cont.6
• MOTOR DATA .................................................................................................1-55
• MULTIPLEXER ...................................................................................................1-57
• OP STATION....................................................................................................1-58
• OPERATOR MENU ...........................................................................................1-59
• PATTERN GEN .................................................................................................1-62
• PHASE AUTO GEAR..........................................................................................1-63
• PHASE CONFIGURE.........................................................................................1-66
• PHASE CONTROL ............................................................................................1-69
• PHASE INCH....................................................................................................1-71
• PHASE MOVE...................................................................................................1-72
• PHASE OFFSET.................................................................................................1-73
• PHASE PID .......................................................................................................1-74
• PHASE REGISTER..............................................................................................1-76
• PHASE TUNING ...............................................................................................1-78
• PID ..................................................................................................................1-79
• PID (TYPE 2).....................................................................................................1-81
• POSITION........................................................................................................1-83
• PRESET.............................................................................................................1-84
• POWER LOSS CNTRL .......................................................................................1-86
• RAISE/LOWER ..................................................................................................1-87
• REFERENCE......................................................................................................1-88
• REFERENCE JOG .............................................................................................1-90
• REFERENCE RAMP ............................................................................................1-91
• REFERENCE STOP ............................................................................................1-93
• REGEN CONTROL ...........................................................................................1-94
• SEQUENCING LOGIC .....................................................................................1-96
• SETPOINT SCALE .............................................................................................1-99
• SKIP FREQUENCIES........................................................................................1-100
• SLEW RATE LIMIT............................................................................................1-102
• SLIP COMP ....................................................................................................1-103
• SPD FBK TRIP .................................................................................................1-104
• SPEED CALC..................................................................................................1-105
•
SPEED LOOP .................................................................................................1-107
• S-RAMP
..........................................................................................................1-110
• STABILISATION ..............................................................................................1-111
• STALL TRIP .....................................................................................................1-112
• SYSTEM OPTION ...........................................................................................1-113
• SYSTEM PORT (P3) .........................................................................................1-114
• TAPER CALC ..................................................................................................1-115
• TEC OPTION .................................................................................................1-118
• TIMER ............................................................................................................1-119
• TORQUE CALC..............................................................................................1-121
• TORQUE LIMIT...............................................................................................1-122
• TRIPS HISTORY...............................................................................................1-123
• TRIPS STATUS.................................................................................................1-124
• VALUE FUNCTION.........................................................................................1-126
• VOLTAGE CONTROL .....................................................................................1-134
• ZERO SPEED ..................................................................................................1-135

Parker 690+ series Specifications

General

Frequency	50/60 Hz
Overload	150% for 60 seconds
Communication Options	Ethernet
Protection Rating	IP20
Operating Temperature	0°C to 55°C
Programmability	Yes
Communication Ports	RS485
I/O Capability	Digital and Analog I/O
Programming Languages	Function Block Diagram
Dimensions	Varies by module