HUNTER-PRO 32 Intruder Alarm System - Installation Manual
10
1.2 Safety Precautions
Your HUNTER-PRO 32 alarm system has been registered with the CE in
accordance with EN 60950 of its rules. The CE requires us to tell you the
following information:
To reduce the risk of fire or electric shock, do not expose this alarm
system to rain or moisture.
Do not open the door of the alarm system. Dangerous high voltages
are present inside of the enclosure. Refer servicing to qualified
personnel only.
This alarm system should be used with AC 230V, 50Hz. To prevent
electric shocks and fire hazards, do NOT use any other power source.
Do not spill liquid of any kind onto the unit. If liquid is accidentally
spilled onto the unit, immediately consult a qualified service.
Install this product in a protected location where no one can trip over
any line or power cored. Protect cords from damage or abrasion.
Disconnect all sources of power supply before proceeding with the
installation.
Connect the AC wires to the terminal block on the PCB as marking. Pay
attention to polarity.
1.3 Signs and Abbreviations Key
Key press
Press and hold key, until confirmation beep is heard
Save data
Press this key at any programming stage in order to return to
root screen
Default Master Code:
5555
“Enabled User Code”
: A code enabled by technician to enter the user menu
To Next Page
Loading...
